General Industrial
Imron® High Performance Urethane DTM Primer
Imron® High Performance Urethane DTM Primer
A two-component, low VOC, direct to metal, urethane primer. It delivers high quality topcoat holdout, minimum over-spray, excellent over spray melt in and high build over properly treated metal substrates.
Features
- Long-term corrosion protection
- High quality topcoat holdout
- Ability to recoat in as little as 5 minutes
Product Details
| Type | Direct to Metal |
| Technology | Urethane |
| Substrates | For use over properly treated substrates such as aluminum, steel, fiberglass and plastic. When used over stainless it is recommended that the substrate be blasted prior toapplication of primer to promote adhesion to the surface. Galvanized steel surface preparation may include detergent washing, pre-treatment andabrasion for new surfaces; for weathered surfaces, detergent washing and sanding. |
| VOC | 2.8 lb/gal (336 g/L) |
Available Sizes
| Size | Case Qty | UPC | GMC |
|---|
Mixing Instructions
| Components | Parts by Volume |
|---|---|
| Imron® 362-300™ Primer Filler | 6 |
| CS8407™ Activator | 1 |
Viscosity
336 g/L (2.8 lbs./gal)
Pot Life
4 hours as activated at 70°F (21°C)
Application Instructions
Application
Pressure pot application is recommended to provide the best atomization and delivery.Fluid delivery is recommended at 10-12 fluid oz/min.
Apply using a cross-coat technique, top-to-bottom, and then side-to-side. Each coat shouldbe medium-wet with no flash between coats.
Paint heaters can help provide a smoother appearance by controlling the temperature andviscosity of the product.
Flash between topcoat a minimum of 5 minutes to a maximum of 16 hours. Dry time over16 hours will require sanding before topcoat.
Apply using a cross-coat technique, top-to-bottom, and then side-to-side. Each coat shouldbe medium-wet with no flash between coats.
Paint heaters can help provide a smoother appearance by controlling the temperature andviscosity of the product.
Flash between topcoat a minimum of 5 minutes to a maximum of 16 hours. Dry time over16 hours will require sanding before topcoat.
Gun Setup & Air Pressure
Refer to technical data sheet
Dry Time
| Air Dry | Force Dry |
|---|---|
| 77°F (25°C) & 50% RH at recommended film thickness | 30 minutes at 140-180°F (60°-82°C) |
| Dry to touch: 15-30 Minutes Tack Free: 30-60 Minutes Print Free: 2-3 hours |
Primer that is force dried prior to topcoat application must be sanded before topcoat can be applied. |
Dry Film Thickness (mil)
Refer to technical data sheet
Special Instructions
Safety
Refer to the product Technical Data Sheet for complete directions for use. Refer to the product Material Safety Data Sheet for safety information. This product may be restricted in it's use and mixing ratio in VOC regulated areas. Refer to your area VOC Compliance Chart.
Packaging Information
You must be an Axalta Coating Systems authorized distributor to view pricing information. Please Login or contact us to learn more.
LOGIN